Skip to content
Sales are only made to entrepreneurs, commercial operators, freelancers and public Institutions and not to consumers within the meaning of §13 BGB.
Sales are only made to entrepreneurs, commercial operators, freelancers and public Institutions and not to consumers within the meaning of §13 BGB.

Filter classes in the welding fume sector - Part III

June 2, 2021 | yourfilter GmbH

What are the different filter classes and what is behind the standards?

Part III - The important standard for filter systems with cleanable filter cartridges and filter plates: DIN EN 60335-2-69

The filters we have dealt with so far are disposed of after saturation. However, there are also filters that are cleaned in the filter system by compressed air and thus have a longer life cycle. Depending on the filter quality and material, the filter can withstand hundreds of cleanings. The most common designation for these filters is "dust class M" or "BGIA/BIA M". But what does this actually mean?

There is also a valid standard for this: DIN EN 60335-2-69. In this standard, dusts are classified into three different dust classes according to their hazard potential:

L = slight hazard

M = medium hazard

H = high hazard

The higher the hazard potential, the higher the requirements for the filter system and filter.

Fig. 1: Welding fumes, the danger at the workplace

Accordingly, the designation "dust class M" indicates that the filters are suitable for systems that can separate dusts with a medium hazard. And welding fumes are among these dusts. Filter cartridges and filter plates should be selected based on whether they comply with this dust class.

The designations BGIA or BIA of the standard ZH 1/487 are outdated, but can also still sometimes be found.

Conclusion: For the area of welding fume extraction, be sure to look for the designation dust class M!

In the next BLOG article: When do filter changes make sense?